12
ENGLISH
Setting the type of speakers
1
Set whether or not speakers are connected and, if so, their size parameters.
• To select the speaker
1 FRNT Small
2
Press the
(down) button to enter the settings and switch to the
SUBWOOFER MODE setting.
• Set up in function of your speaker systems. Performing this setup optimizes the system.
• The composition of the signals output to the different channels and the frequency response are adjusted
automatically according to the combination of speakers actually being used.
Center Sp.
Front Sp.
Front Sp.
Listening position
Surround back Sp.
Subwoofer
Surround Sp.
Surround Sp.
• To select the parameter
• Parameters
Large…… Select this when using speakers that can fully reproduce low sounds of below 80 Hz.
Small…… Select this when using speakers that cannot reproduce low sounds of below 80 Hz with sufficient
volume. When this setting is selected, low frequencies of below 80 Hz are assigned to the
subwoofer.
None…… Select this when no speakers are installed.
Yes/No…. Select “Yes” when a subwoofer is installed, “No” when it’s not installed.
NOTE:
Select “Large” or “Small” not according to the physical size of the speaker, but according to the bass
reproduction capacity at 80 Hz. If you cannot determine the best setting, try comparing the sound when set to
“Small” and when set to “Large”, at a level that will not damage the speakers.
Caution:
In case the subwoofer is not used, be sure to set “Subwoofer = No”, or the bass sound of front channel is
divided to subwoofer channel and not reproduced in some mode.
If the subwoofer has sufficient low frequency playback capacity, good sound can be achieved even when
“Small” is set for the front, center and surround speakers.
For the majority of speaker system configurations, using the Small setting for all five main speakers and
Subwooofer On with a connected subwoofer will yield the best results.
Setting the Subwoofer mode and Crossover Frequency
This screen is not displayed when not using a subwoofer.
• Set the crossover frequency and subwoofer mode according to the speaker system being used.
1
Select the “Subwoofer
Mode”.
Select the setting.
6 MODE NORM
2
Select the “Crossover
Frequency” mode.
Select the frequency.
7 CR.OVER 120
3
Press the ENTER button to enter the setting and switch to the DELAY TIME
setting.
Summary of Contents for AVR-770SD
Page 286: ...286 MEMO...
Page 287: ......
