5
Operation
You can play audio from an audio device that sends its signal over a Bluetooth connection
(e.g., smartphones, tablet computers, etc.). DN-200AZB uses Bluetooth CSR 4.0 and has a
transmission range up to 100 feet (30.5 meters).
Once you “pair” your Bluetooth device with DN-200AZB, they are “connected” wirelessly. You
can play audio on your Bluetooth device, and it will be sent out of DN-200AZB’s
outputs
.
Important:
•
DN-200AZB will not receive audio from a phone call. While using it, we recommend
disabling your cellular connection, if possible.
•
Do not use DN-200AZB near a microwave oven, which can interfere with the reception.
•
While DN-200AZB is paired with a Bluetooth device, other Bluetooth devices cannot pair
to it. You must unpair (“disconnect”) the current Bluetooth device from DN-200AZB to
make it available to others.
To pair your Bluetooth device to DN-200AZB:
1.
If DN-200AZB is off, use the included
power adapter
to connect its
power input
to your
power source. The
Status
Light
will begin flashing.
2.
Make sure your desired Bluetooth device has its Bluetooth connectivity on and is within
range. DN-200AZB will automatically try to pair with the last-paired Bluetooth device, if
any. If you are using that Bluetooth device again, you can start playing audio immediately.
If you want to use a different Bluetooth device, continue to
Step 3
.
3.
On your Bluetooth device, enter its Bluetooth settings menu, and select
DN-200AZB
.
When DN-200AZB successfully pairs to a Bluetooth device, the
Status Light
will stop
flashing and remain lit.
Note:
(Some older Bluetooth devices may require you to enter a PIN. If this is the case,
enter
0000
as the PIN.)
If no device pairs within 20 seconds, DN-200AZB will exit pairing mode and the LED will
turn off. To re-enter pairing mode, press and hold DN-200AZB’s
Pair
button for
3
seconds.
When the
Status
Light
starts flashing, release the
Pair
button.
4.
On your Bluetooth device, start playing audio.
To adjust your volume level, we recommend setting the volume control of your devices in
the following order:
i.
your Bluetooth device
ii.
your receiver, if any (its input channel level[s], then its main output level)
iii.
DN-200AZB, using its
Level Knob
Set each volume level as high as possible without creating distortion or any “clipping” of
the sound.
Important:
DN-200AZB will not receive audio from a phone call. While using it, we
recommend disabling your cellular connection, if possible.
To unpair your Bluetooth device from DN-200AZB,
do one of the following:
•
Enter your Bluetooth device’s Bluetooth settings menu, and disconnect from
DN-200AZB
.
•
Press and hold DN-200AZB’s
Pair
button for
3
seconds, and then release it. DN-200AZB
will unpair from your Bluetooth device and be available to pair to another one.
