5.6.3
Control pendant height adjustment
Fig. 15
x
Control cable locking mechanism engaged
y
Control cable locking mechanism released
1.
Undo the screws of the service cover.
2.
Open and disconnect the service cover.
3.
Remove and open the bag with the control cable.
4.
Take the control cable out of the bag.
5.
Slide the latch of the control cable locking mechanism upwards and hold it in place. At the same time, pull
the control cable until the correct height has been reached for the control pendant.
6.
If the control pendant is positioned too low, pull on the control cable hose behind the service cover. Slide the
latch of the control cable locking mechanism downwards and lock the retainer by a short, strong pull on the
control cable above the control pendant.
7.
Lay the remaining control cable in loops and store it in the bag. The bag must be located behind the edge of
the chain collector box. Close the service cover (tightening torque = 5,5 Nm).
214
80
2 44/291
113
37
Summary of Contents for DC-Com 1
