DEMAG DC-Com 1, Operating Instructions Manual

Page: 35 / 116

5.5 Connecting the control pendant
Fig. 12
The control pendant is of plug-in design. The connector on the end of the control cable is locked in the bayonet
sleeve and can be turned. If a connector is not locked, it can be pulled out and must be locked again by pressure.
Unless the chain hoist is supplied with the control pendant fitted, connect the DSC control pendant with the con‐
trol cable and lock the connection with the bayonet lock as follows:
1. Lift bend protection sleeve (1) on the control pendant off the two pins.
2. Then pull bend protection sleeve (1) off the control pendant.
3. Slide bend protection sleeve (1) onto the control cable. Plug the control cable into the control pendant and
turn the bayonet lock until it is locked. Ensure that
– groove (a) on the connector holder lines up with swivel lock (b) in the control pendant housing and
– that the two pins (c) on the control pendant housing line up with bayonet lock (d).
4. Slide bend protection sleeve (1) over the control pendant again. Pay attention to the positioning markers.
Press bend protection sleeve (1) firmly onto the control pendant.
The control pendant can be attached to the chain hoist or installed as a travelling unit, see  "Mobile control sys‐
tem", Page 38.
214
80
2 44/291
113
35