RDM Network Scanner User Guide
Maintaining your scanner
©2021 RDM Corporation
Page 31
Installing the endorser inkjet cartridge
When you place the new inkjet cartridge into the holder for the EC9600i series, make sure that you
insert it at the angle described in the following steps. If you do not insert the cartridge properly, it might
not make contact with the document when it is scanned.
1.
Remove the endorsement printer cover.
2.
Pull the inkjet latch away from the inkjet cartridge (as pictured).
3.
Pull the inkjet cartridge out of the scanner.
4.
To insert the new inkjet cartridge, pull the inkjet latch
back and place the inkjet cartridge into the holder.
The cartridge needs to be at an angle so that the back
of the cartridge is lower than the front of the
cartridge.
5.
Push the cartridge down into the holder until the
cartridge snaps into place.
Once installed, the inkjet cartridge sits on a slight
angle with the back of the cartridge lower than the front.
6.
Make sure there is no gap between the inkjet cartridge and the endorsement channel.
7.
Replace the endorsement printer cover.
How to Install the Inkjet Cartridge
Alternatively visit:
https://www.youtube.com/user/RDMCorporation/playlists
