EC9100i Series Scanner User Guide
Maintaining your scanner
©2021 RDM Corporation
Page 27
Replacing the inkjet blotter
Scanners with endorsement printers include an inkjet blotter that absorbs excess ink from the
endorsement process. Over time, the blotter might stop absorbing ink effectively and so should be
replaced. Scanners with endorsement printers come with five replacement blotters.
To replace the inkjet blotter:
1.
Remove the front cover of the scanner.
At the back of the scanner, above the franker cartridge, you can
see the top of the inkjet blotter, as shown below:
2.
With your finger or tweezers, remove the inkjet blotter from its
slot.
3.
Dispose of the used blotter.
4.
Insert the replacement inkjet blotter into the slot.
Replacing the paper roll for the printer
If your scanner has a printer, the following steps describe how to
replace the paper roll.
1.
Press the printer door release button and completely open the
printer door.
2.
Remove the empty paper roll from the paper compartment.
3.
Insert the new paper roll into the compartment, with the end of
the paper roll rolling from the top.
4.
Pull the paper out of the compartment and close the printer
door so that the end of the paper sticks out of the compartment
(as pictured). Push the door closed in the center of the printer
door.
Make sure the cover is completely closed. If you push the cover from the sides, the cover might
not close completely. When closed correctly, both sides of the printer cover are flush with the
scanner.
5.
Rip off any access paper sticking out of the printer cover.