STEP BY STEP ILLUSTRATED INSTRUCTIONS
READ COMPLETE INSTRUCTIONS BEFORE INSTALLING YOUR
SINGLE HANDLE SINGLE MOUNT WASHERLESS KITCHEN FAUCET
Leave this instruction sheet with installed faucet and write
purchased model number here for future reference!
27816
27816
27816
27816
27816
27816
27816
27816
27816
27816
27816
27816
27816
27816
27816
27816
27816
27816
27816
27816
27816
27816
27816
27816
1
Step 1. Shut off water supply. Remove your
Delta SBS
®
faucet from the package. Place base and
gasket on faucet making sure gasket is aligned in
cavity of base. Note: If sink is uneven or gasket does
not properly seal, use of silicone sealant in place of
gasket may be required.
Step 2. Feed tubes down through center hole of sink.
Secure faucet to sink with washer and spacer
(IF REQUIRED), using wrench.
Step 3. Make connections to water supplies.
IMPORTANT: After installation is complete, remove
aerator, turn handle to full on mixed position. Turn on
water supplies, check for leaks and let lines flush for
one minute without moving faucet handle. This will
remove any debris from lines which can damage
internal parts of faucet and create leaks. After flushing
shut off water at faucet and replace aerator.
INSTALLATION STEPS
IMPORTANT: USE TEFLON
®
TAPE ON ALL
THREADED CONNECTIONS
RP90
Handle w/Set Screw
RP152
Set Screw
RP50
Cap w/Adjusting Ring
RP4993
Seats & Springs
RP5786
Base w/Gasket
RP6052
Gasket
RP5785
Wrench
RP61
Cam & Packing
RP250
Adjusting Ring
RP70
Ball Assembly
RP6893
Washer
RP12691
Spacer
RP330
Aerator
RP5861
Nuts
RP5654
Spout
RP25
O-Rings
RP1974
Wrench
(Accessory Order Only)
The
Delta SBS
®
products shown here are protected by one or more of the following U.S. Patents: 4,043,359, 3,786,995, 4,562,960, 4,593,430, 4,089,347, 4,218,785, 4,696,322, 4,765,365. More patents are pending.
7/13/01
Rev.B
MODEL 81400-SBS
®
U P
C
Limited Warranty
All parts of this
Delta SBS
®
product are warranted to the original consumer purchaser to be free from defects in material and workmanship for a period of five (5) years from date of purchase as shown on
purchasers receipt.
MASCO PLUMBING PRODUCTS DIVISION
will replace, FREE OF CHARGE, during the warranty period, any part which proves defective in material and/or workmanship under normal installation, use, and
service. Replacement parts can be obtained from your dealer or by returning the part to our factory. TRANSPORTATION CHARGES PREPAID, at the address listed on back. THIS WARRANTY IS THE
EXCLUSIVE WARRANTY GRANTED BY
MASCO PLUMBING PRODUCTS DIVISION
AND IS IN LIEU OF ALL OTHER WARRANTIES INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE AND IS FURTHER LIMITED TO DEFECTIVE PARTS REPLACEMENT ONLY. LABOR CHARGES AND/OR DAMAGE INCURRED IN INSTALLATION, REPAIR,
OR REPLACEMENT AS WELL AS INCIDENTAL AND CONSEQUENTIAL DAMAGES CONNECTED THEREWITH ARE EXCLUDED AND WILL NOT BE PAID BY
MASCO PLUMBING PRODUCTS DIVISION
.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. Any damage to this faucet as a result of misuse, abuse,
neglect, accident, improper installation, any use violative of instructions furnished by us, or any use of replacement parts other than genuine
Delta
parts WILL VOID THE WARRANTY.
®
U
L
®
CL
ASSIFIED
Drinking Water Systems Components
CLASSIFIED BY
UNDER
UNDERWRITERS LABORATORIES INC.
In Accordance with Standard
ANSI/NSF 61-97b
21PL
®
CSA B125-93
ASME A112.18.1M-96
®
CSA B125-93
ASME A112.18.1M-96
