Delta RTU-CN01, Operation Manual

Page: 67 / 89

RTU-CN01 Operation Manual
7-14
_7

See the
following
diagrams for the digital - analog relations for DVP04DA-S and DVP04AD-S.
V
ol
ta
ge
ou
tp
ut
Digital input
0
+2000 +4000
5V
10V
Digital input -voltage output relation
for DVP04DA S in mode 0
-
Mode 0
Voltage input
D
ig
ita
lo
ut
pu
t
0
5V 10V
+4000
+8000
Voltage input- digital output relation
for DVP04AD S in mode 0
-
-10V
-5V
-8000
-4000
Mode 0
7.2 Example of Using RTU-CN01 with Non-Delta Master Together
Here the third-party software (Schneider) is used to directly configure the PDO parameters which are used in
section 7.1 in the PDO mapping window. You can learn from this section about how to configure
RTU-CN01-related parameters via the third-party software.
7.2.1 Setting Baud Rate
The CANbus page appears with a click on “CAN0”, where the baud rate is set. Please ensure that the baud
rate of the master must be the same as that of acutally connected RTU-CN01.
For the baud rate setup of RTU-CN01, refer to Function Switch in Section 2.6.