83
Installation and Operation Manual for RPI M50A
8 Settings
83
Installation and Operation Manual for RPI M50A
8.18 FRT (Fault Ride Through)
Overview
Values have been set based upon country standards. If you modify these values, you will lose certi-
fi cation. Therefore you should set this function only when requested by country regulations, authori-
ties or your grid operator.
With this function you can set the operation behavior of the inverter for FRT (Fault Ride Through).
Fig. 8.28: Operation behavior for FRT (Fault Ride Through)
t1 : The point in time when the fault occurs.
Accessing the menu
Main menu > FRT
E-Today: 0kWh
Power: 0W
Status: On Grid
10.Sep 2014 15:32
1.
When the default information is displayed, press any button to open the
main menu. Otherwise, repeatedly press the button
ESC
until the main
menu is displayed.
Inverter Info.
General Settings
Install Settings
Active/Reactive Pwr
FRT
2.
Use the buttons
and
to select
FRT
.
To confi rm your selection, press the button
ENT
.
3.
The menu is protected by password 5555. Use the buttons
and
to set each digit.
To confi rm a digit, press the button
ENT
.
Do not change this setting without prior
consultation with Delta Solar Support.
