Delta PhotoVoltaic RPI-C500, Manual

Page: 55 / 176

I
NSTALLATION
G
UIDE
49
I
NSTALLATION
S
ETTINGS
Table 5-4: Grid Setting Parameters (Continued)
Fac Low Off Slow
The function is same as Fac Low Off, but the value must be higher than
former.
Fac Low On Slow
The function is same as Fac Low On, but the value must be higher than
former.
Fac Low Off Slow T
The function is same as Fac High Off T, but the time must be longer than
former.
Reconnection Time The countdown time before inverter connected to grid.
Note:
Once you change any item listed above, the country will be turn to
“Custom”.
You can go back the original country via re-selecting the country in the page
“Install
settings
” - “Country”.
5.11.7.4. Active/Reactive Power Control
Only when country sets as Germany MV, China, or India can user enters this page.
User has to enter user’s password before enter this page.
Figure 5-42. Active/Reactive power setting page
5.11.7.4.1. Power Limit
User can set percentage of actual or rated power to limit inverter’s output power.
Inverter will
start the action once user set Mode as “ON”. On the contrary, inverter will
stop power reduction and back to MPP Tracking once user set Mode as “OFF”.
Figure 5-43. Power limit setting page
ENT
EXIT
*1
*2
*3
Settings
21. Jun 2010 13:50
Coefficients Settings
Personal Settings
Install Settings
Active/Reactive Power Control
FRT
Active/Reactive Power
21. Jun 2010 13:50
Reactive Power Control
Active Power Control
*
Password
21. Jun 2010 13:50
*
ENT
ENT
EXIT