Model Number: IT414071C
MAGNETIC DOOR ALARM WITH KEYPAD
GETTING STARTED GUIDE
2. Connect the batteries
a. Open the battery panel from the back of the alarm.
b. Remove the plastic tab to activate the batteries.
1. Unpack
a. Unpack the Delta Magnetic Door Alarm with Keypad.
3. Set Your Personal Alarm Code
a. Press the “Reset” button and wait for the red light
on the front of the alarm to start flashing.
b. Input your chosen 4 digit code while the red light
is flashing.
c. The light will change to green and flash 3 times to
confirm the code has been validated.
4. Install the Alarm and Sensor
Note:
Ensure the surface you are mounting to is clean and dry
before attaching the unit or magnetic sensor
a. Attach the mounting plate on to the back of the unit as
shown.
b. Find a suitable location for the alarm where the alarm
and sensor are within 2cm of each other when the door
or window is closed.
Note:
The alarm should be attached to the door or window,
the sensor should be attached to the frame
c. Attach the alarm and sensor by peeling the backing off
the adhesive tape.
d. Press firmly and hold for 30 seconds to ensure a strong
adhesion.
Home/Away
Switch
Alarm/Chime
Switch
Reset Button
Keypad
Magnetic
Sensor
2a
3a
4a
4b
5. Switch Off when not in Use
a. Once finished with the Magnetic Door Alarm with Keypad, ensure you turn the unit off by removing the batteries.
Note:
If you will not be using the unit for an extended period, remove the batteries before storing.
