Delta 46-408, Instruction Manual

Page: 7 / 20

7
For Delta Model DL-40 16” Wood Lathe Only
1. Insert two T-bolts (A) Fig. 28 into channel (B1) located on the left underside of duplicator rail (C).
2. Insert the two remaining T-bolts to the right underside of the duplicator rail (B2) in the same manner.
3. IMPORTANT: To prevent personal injury or damage to the duplicator, use two or more people to mount the
duplicator to the mounting brackets .
4. Carefully guide the duplicator rail (C) Fig. 29, so four T-bolts (A) fit into four slots (D) in mounting brackets. Fasten
duplicator rail (C) Fig. 29 to the mounting brackets using four M10 flat washers and M10 hex nuts (F).
5. Tighten four M10 hex nuts (F) Fig. 30 only enough to hold the
duplicator rail in place on the mounting brackets.
6.
Slide duplicator rail (C) Fig. 31 to the left until edge of rail is
approximately 1" from right side (G) of headstock.
7.
Tighten hardware (F) Fig. 30.
Fig. 28 Fig. 29
Fig. 30
Fig. 31
For Delta 12” Wood Lathes Only
1. Slide two T-bolts (A) Fig. 32 into channel (B) located at the rear of duplicator rail.
2. Place mounting pad (D) Fig. 33 between two T-bolts (A) and slide T-bolts inward in slots of mounting pad (D). Fasten
with two M10 flat washers and M10 hex nuts (E). NOTE: Loosely tighten hardware.
3. Attach remaining mounting pad (D) Fig. 34 to the other end of duplicator rail (C) in the same manner.
4. IMPORTANT: To prevent personal injury or damage to the duplicator, use two or more people mount the duplicator to
the mounting brackets.
Fig. 32 Fig. 33
Fig. 34
C
B1
A
C
B
A
D
F
A
D
F
F
F
G
C
B
A
A
E D
E
C
D
B2