Delta 17-935, Manual

Page: 1 / 8

Part No. 1343761 - 12-16-04
DELTA ACCESSORY
MODEL 17-935 & MODEL 17-924
MORTISING ATTACHMENT
CARTON CONTENTS
Mortising Attachment Assembled
1. Fence
2. Locking Levers (2)
3. Flat washers (2)
4. T-Nuts
5. Guides
6. Hold-Down Assembly
7. Hold-Down Shaft
8. 5/32" Hex Wrench
9. Quill Alignment Pin
10. Chisel Holder
11. Small ID Split-Ring Bushings - for 10", 12", and 32" Radial Drill Presses
12. Intermediate Split-Ring Bushings - for 14" Drill Presses
13. Large ID Split-Ring Bushings - for 15" and 16-1/2" Drill Presses
14. Carrying Case (For Model 17-924 Mortising Attachment ONLY)
15. Set of Chisels and Bits (4) - 1/4", 5/16", 3/8", and 1/2"
(Furnished with Model 17-924 Mortising Attachment ONLY)
INSTALLATION
IMPORTANT: Use the correct bushings as indicated in the carton contents for your machine. Any others will not
work. The 16-1/2" drill press (Model 17-900) does not require bushings.
INTRODUCTION
The 17-924 Mortising Attachment converts your drill press into an accurate mortising machine and can be used with
the following units:
11-980 Drill Press (10")
14-070 Drill Press (14")
17-925 Drill Press (16-1/2") 11-990 Drill Press (12")
11-090 Radial Drill Press (32")
Delta Utility Drill Presses (15")
14-040 Drill Press (14")
17-900 Drill Press (16-1/2")
61962
RTD10000125AA