____________________________________________
Page
3
UNPACKING
Carefully remove all packing material and keep it safe so that it can be re-used to
transport the system in the future. Using the packing list(s), make sure that the
consignment is complete.
Identify each component using the parts lists and drawings in this manual.
Check for damage. If you notice any damage notify your supplier.
BASIC ROOT WASHER ASSEMBLY
Using the drawings shown on pages 4 complete the assembly by plugging the
yellow & grey connectors to each other.
Lay the table on its face and partially push one leg into its aperture. Push the
funnel mounting frame into the hole up the inside of the leg, partially insert a leg
in the opposite aperture whilst fitting the mounting frame into its hole. Continue
this procedure with the other two legs, making sure the frame is supported by the
four legs before pushing them fully into their apertures in the table.
Turn the whole assembly over, if you have a root washer catch tank, type RWT,
stand the whole assembly roughly in the centre. One of the legs has an adjustable
foot, use this to get the table level and stable. Put the four orange root funnels
complete with their 550 micron filters into the mounting frame.
Fit the table funnels into their holes in the table top and then stand the four
buckets over these holes. Arrange the hoses to the best positions that will easy
access to the 4-way controller and spray gun.
Inside each bucket are two nozzle assemblies, the jets of these may have been
moved in transit or during assembly, adjust them so that they point horizontally
in a clockwise direction and secure with a spanner.
Select one of the four threaded connectors provided, to suit your tap fitting. If
your local water supply connection is not compatible you will have to seek
advice from a plumber or water engineer for help.
