20
GB
Possible errors
Potential errors are listed below, along with their causes and how to rectify them.
Error
Possible cause
Remedy
Remote control
(2) does not
respond.
Remote control (2) is
switched off.
Turn on remote control (2).
Batteries (5) incorrectly
inserted.
Insert the batteries (5) correctly.
Batteries (5) are flat.
Replace the batteries (5).
The quadcopter
(1) does not
respond.
The batteries (5) in the
remote control (2) were
incorrectly inserted or
are flat.
Check the batteries (5) and replace if necessary.
The rechargeable battery
(3) in the quadcopter (1)
is flat.
Charge the rechargeable battery (3).
The indicator lights (1g)
do not flash or light up.
Insert the rechargeable battery (3) into the
quadcopter until it locks firmly in place.
The quadcopter (1) is out
of range.
Make sure that the distance between the remote
control (2) and the quadcopter (1) is not more than
30m.
The quadcopter
(1) cannot be
controlled.
Too strong a wind or
draught.
The quadcopter (1) is only suitable for calm conditions
with no wind or up to force 3 winds.
The quadcopter (1) needs
to be calibrated.
Place the powered-on quadcopter (1) on a horizontal,
level surface. Simultaneously slide the throttle (2h)
and the control lever (2l) on the powered-on remote
control (2) towards yourself and at an angle outwards.
The indicator lights (1g) on the quadcopter (1) will
flash for approx. 3 seconds. Once the indicator
lights (1g) are steadily illuminated, the calibration is
complete and the quadcopter (1) is ready to fly.
NOTE:
repeat the calibration if the quadcopter
(1) still flies erratically in one direction.
The quadcopter
(1) will not fly
upwards.
Not enough throttle.
Slide the throttle (2h) forward completely.
The rechargeable battery
(3) is flat.
Charge the rechargeable battery (3).
The rotor
guards (1c) are
not securely
fixed.
Collision, crash.
If the rotor guards (1c) become loose, firmly reattach
them and check the function and correct placement of
the rotor guards (1c).
The quadcopter
(1) indicator
lights (1g) flash
alternately.
Contact has not been
established between the
quadcopter (1) and the
remote control (2).
Slide the throttle (2h) on the remote control (2) all the
way forward, and then all the way back.
This process establishes contact between the
quadcopter (1) and the remote control (2).
The rechargeable battery
(3) is almost flat.
Switch off the quadcopter (1) and remove the
rechargeable battery (3), so it can be charged.
