22
Maintenance and Cleaning
Before performing maintenance and cleaning, please be sure to switch off the power first.
Brush cleaning and maintenance:
Use dry cotton cloth to wipe the front end of the brush in
order to remove dirt. Manually rotate the brush to check
whether it is damaged such that it cannot contact with screw
heads and adjust its height. For brush worn out to form no
contacts with screw heads, it shall be replaced with a new
one.
Track cleaning and maintenance:
Remove the track from the machine, and use cotton dipped
with alcohol or cleaning naphtha to wipe the track, and the
screw sliding surface inside the track in particular. Use the
equipped hex-key wrench to check whether the screws at all
parts are fastened tightly.
Machine cleaning and maintenance:
After cleaning the track, remove all screws foreign objects
fall into the machine, in particular, the locations at the parts
of the motor, PCB board and gears etc.
Selection and purchase of accessories:
Please use spare parts of the original manufacturer; otherwise, the normal operation of the machine
may be affected in the future.
Other:
When there is a need to use screws of special shapes, please contact us immediately.
