Delta OHM HD32MT.3, Operating Manual

Page: 39 / 62

HD32MT.3
- 39 -
V1.2
11.10 A
NALOG INPUTS SETTINGS
Command Description P
Analog input A
ADCONVGAIN_A Prints the gain set for analog input A.

ADCONVGAIN_A gain Sets the gain of the analog input A to the gain value (resolution 0.001).

ADCONVOFFS_A Prints the offset set for analog input A.

ADCONVOFFS_A offset Sets the offset of the analog input A to the offset value (resolution
0.001).

ADCONVUNIT_A Prints the unit of measurement set for analog input A.

ADCONVUNIT_A u Sets the unit of measurement of index u for analog input A.
For the list of units, see paragraph 11.5.

Analog input B
ADCONVGAIN_B Prints the gain set for analog input B.

ADCONVGAIN_B gain Sets the gain of the analog input B to the gain value (resolution 0,001).

ADCONVOFFS_B Prints the offset set for analog input B.

ADCONVOFFS_B offset Sets the offset of the analog input B to the offset value (resolution
0.001).

ADCONVUNIT_B Prints the unit of measurement set for analog input B.

ADCONVUNIT_B u Sets the unit of measurement of index u for analog input B.
For the list of units, see paragraph 11.5.

Analog input C
ADCONVGAIN_C Prints the gain set for analog input C.

ADCONVGAIN_C gain Sets the gain of the analog input C to the gain value (resolution 0,001).

ADCONVOFFS_C Prints the offset set for analog input C.

ADCONVOFFS_C offset Sets the offset of the analog input C to the offset value (resolution
0.001).

ADCONVUNIT_C Prints the unit of measurement set for analog input C.

ADCONVUNIT_C u Sets the unit of measurement of index u for analog input C.
For the list of units, see paragraph 11.5.

11.11 SDI-12
SETTINGS
Command Description P
SDIECHO Prints the replies of the SDI-12 sensors for 60 seconds (to check the
operation of the sensors).
Note: the commands sent to the sensors are not printed.

SDICOMMAND c...c Sends the SDI-12 command defined by the string c...c.
Example: “SDICOMMAND 0A1!” changes from 0 to 1 the address of
the sensor which currently has address 0.
Note: this command should be used only if the SDI-12 sensors are not
active, to avoid interference with the measuring cycle (if the sensors
are active, disable them by using the command SENSORCONFIG).

SDINUMBEROFMEAS n m Sets the number of measurements of the SDI-12 sensor with address
n (n=1...4) to the value m (m=1...8).

SDIMEASCONFIG n m u r Sets the unit of measurement of index u and the resolution r for the
measurement number m (m=1...8) of the SDI-12 sensor with address
n (n=1...4).
See the command LISTUNITCODES for the list of the units of measure-
ment.
r is the number of decimals of the measure (r=0...7).
