SAFETY INSTRUCTIONS
ISO AMP
2 / 7
DELTA ELEKTRONIKA B.V.
rev. Febr. 2021
This marking shown on the product, its packing or its literature indicates that it should not be disposed with
other wastes at the end of its working life, but should be collected separately to recycle it responsibly to
promote the sustainable reuse of material resources.
2
SAFETY INSTRUCTIONS
– ISO AMP - series
2.1
Caution
The following safety precautions must be observed during all phases of operation, service and repair of this equipment.
Failure to comply with the safety precautions or warnings in this document violates safety standards of design,
manufacture and intended use of this equipment and may impair the built-in protections. Delta Elektronika shall not be
liable for user’s failure to comply with these requirements.
2.2
Installation Category
The Delta Elektronika interfaces have been evaluated to installation category II (Over voltage category II).
2.3
Grounding
This product is a safety Class 1 equipment. For safety isolation both the metal assembly terminals next to the 15p
connector must be firmly connected to the metal chassis of a grounded Delta Elektronika power supply. Any interruption
of the protective ground conductor, or disconnection of the metal terminals will cause a potential shock hazard that might
cause personal injury.
For grounding of the power supply, see the specific power supply operating manual for detailed safety instructions.
2.4
Live Circuits
Operating personnel should not remove the unit covers. No internal adjustment or component replacement is allowed by
non Delta Elektronika qualified personnel. Never replace components with the power cable connected. To avoid injuries,
always disconnect power, remove external voltage sources and discharge circuits before touching components.
2.5
Parts Substitutions & Modifications
Parts substitutions and modifications are allowed by authorized Delta Elektronika service personnel only. For repairs the
unit must be returned to a Delta Elektronika service facility.
2.6
Removal of (safety) covers
Safety cover(s) are used to cover potentially hazardous voltages.
Observe the following when removing safety cover(s):
Switch off the unit and disconnect the unit from the AC mains supply and from the DC power application.
Wait for 5 minutes to allow internal capacitors to discharge, then unscrew and remove the cover(s).
Always place the cover(s) back before connecting the unit to the mains supply again.
2.7
Environmental Conditions
The Delta Elektronika power supplies safety approval applies to the following operating conditions:
Usage
: Indoor use only.
Warning!
Not intended to be used in the presence of children or animals!
Ambient temperature
: -20 to 50 °C.
Maximum relative humidity
: 95%, non condensing, up to 40 °C, 75%, non condensing, up to 50 °C.
Altitude
: Do not use above 2000 m sea level.
Warning!
Electrical Creepage & Clearance not valid for higher altitudes!
Pollution degree
: 2
2.8
Symbols & markings
WEEE (Waste Electrical & Electronic Equipment)
1.1
Correct Disposal of this Product
Applicable in the European Union.
Caution risk of electrical Shock.
Instruction manual symbol. The instrument will be marked with this symbol when it is
necessary fort he user to refer to the instruction manual.
Protective ground conductor terminal.
Off (supply).
On (supply).