Delta Electronics USB Interface CME-USB01 Instruction Sheet Download Page 1

                                                                                                           

2007-07-09

5011659301-SBT1

 

CME-USB01 

USB Interface for VFD-E Series Instruction Sheet

 

 

 Please thoroughly read this instruction sheet before installing option cards and putting them into 

use. 

 The content of this instruction sheet may be revised without prior notice. Please consult our 

distributors or download the most updated version at http://www.delta.com.tw/industrialautomation/. 

X

 Layout 

 

USB Card (CME-USB01) 

 

 

 

Y

 Installation

 

 

Make sure that the AC Motor Drive is powered 
off before operation. DO NOT insert or remove 
the card when the AC Motor Drive is powered 
on. 

 

Please mount the extension card as shown and 
fix it with the screw packed with the card. 

Screw torque: 
Maximum 2kgf-cm

 

 

USB Cable 

USB Type B to CME-USB01

USB Type A to PC 

NOTE

 

 

Refer to Chapter 5: Parameters 9 (Group 9) in 
the user manual for further details. 

Z

 

Specification 

 

Environmental 

 

Operating 
Temperature

-10

o

C to 50

o

C (non-condensing 

and not frozen) 

Storage 
Temperature

-20

o

C to + 60

o

Ambient 
Humidity 

Less than 90%RH   
(non-condensing) 

Installation 
Altitude 

Below 1000m 

Vibration 

Less than 20Hz:   
Maximum 9.81 m/s

2

 (1G);   

20 ~ 50Hz:   
Maximum 5.88 m/s

2

 (0.6G) 

 

NOTE

 

 

Always use this product in a clean indoor 
location free from dust, corrosive gas and liquid. 

 

Inputs/Outputs 

 

Baud Rate 

Supports 4800, 9600, 19200, 
38400, 57600 bps. 

USB 

Specification

USB v1.1 

 

[

 Notes

 

 

Please use shielded wires to avoid interferences 
and connect the shield to ground. 

 

To avoid interference, route the extension card 
wires separately and as far away (at least 15cm) 
as possible from other control wires, motor wires 
and power wires, etc. Where these wires must 
cross each other, please make sure they are at 
a 90

angle. 

 

Always use and operate this product within the 
limit of its specifications.

Reviews: