Delta Electronics B07S200, Quick Start Manual

Page: 4 / 25

English-3
Installation Method:
Step 1: Ensure to put waterproof gasket into HMI
and then insert the HMI into the panel cutout. Step 2: Ensure to insert fasteners into the HMI’s
insertion slots and turn the screw till screws touch
panel cutout.
Step 3: Turn the screw with less than torque
0.7N.M to avoid damage to plastic box. Torque:
6.17lb-inch(0.7N-M) Step 4: Keep at least 60mm distance from rear of
HMI product to the wall, installation surface or the
other controllers for heat dissipation.
Power Line Installation
Recommended wiring is in the table below:
Type Wire Gauge (AWG) Stripped length Torque
Solid 28 ~ 12 7 ~ 8 mm 5 Kg-cm
Stranded 30 ~ 12 7 ~ 8 mm 5 Kg-cm
Be sure to plug power line into HMI according to following arrow direction.
DOP-B07S200
Units:mm