Delta Electronics ASD-B0121-A, User Manual

Page: 58 / 321

Chapter 4 Display and Operation
|
ASDA-B Series
Revision January 2009
4-3
4.1.2 Display Flowchart
Monitor Mode, Parameter Mode and Parameter Setting Mode
1. When the power is applied to the AC servo drive, the digital keypad will execute communication
initial setup for approximately two seconds (9600bps & 7,N,2 Modbus ASCII) first, and then enter
into the monitor mode.
2. In monitor mode, pressing UP or DOWN arrow key can switch monitor parameter code.
3. In monitor mode, pressing MODE key can enter into parameter mode, pressing the SHIFT key
can switch parameter group and pressing UP or DOWN arrow key can change parameter group
code.
4. In parameter mode, system will enter into the parameter setting mode immediately after the SET
key is pressed. The LCD display will display the corresponding setting value of this parameter
simultaneously. Then, users can use UP or DOWN arrow key to change parameter value or press
MODE key to exit and return back to the parameter mode.
5. In parameter setting mode, users can move the cursor to left by pressing the SHIFT key and
change the parameter settings (blinking digits) by pressing the UP or DOWN arrow key.
6. After the setting value change is completed, press SET key to save parameter settings or execute
command.
7. When the parameter setting is completed, LCD display will show the end code “-SET END-“ and
automatically return back to parameter mode.
Figure 4.2
STS01:Fb REV
0 rev STS02:CMD PULSE
0 pulse
STS15:IGBT temp
33 degC
P0-00:VER
0.005 P0-01:ALE
0 P0-02:STS
0
P1-00:PTT
2
P1-01:CTL
0
P1-02:PSTL
0
P2-00:KPP
70 rad/s
P2-01:PPR
100 % P2-02:PFG
50 %
P3-00:ADR
1 P3-01:BRT
3 bps P3-02:PTL
0
P4-00:ASH1
1 P4-01:ASH2
1
P4-02:ASH3
1
P8-00:VERSION
1.001
P8-01:MISC FUN
1 P8-05:KPD ID
255
10000
10001
SET END
SET
GROUP0
STS00:Fb PULSE
0 pulse
GROUP1
GROUP2
GROUP3
GROUP4
GROUP8
SET
Edit Setting Values
MODE
SHIFT
SHIFT
SHIFT
SHIFT
SHIFT
Save Setting Values
Parameter Mode
Monitor Mode
Parameter
Setting Mode