EN
7
6
2/ Wireless association
If you own a solar motor, refer to its instructions.
2.1 Pairing of a motor in
individual control mode
When connecting to the power supply, a motor that
has never been wirelessly paired before will always
perform a brief movement. It is set to pending
pairing for 10 minutes.
2.1.1 If only a single motor is turned on
❶
On the remote control, press
1
2
and
1
2
at the
same time and hold for 3 seconds, until the LED
flashes. Release the buttons.
When the motor is detected, the LED briefly lights up
green.
❷
After a few seconds, the shutter activates
twice to confirm pairing, and the remote control
automatically exits pairing mode.
❸
Then proceed with the setting of the stops (see
motor instructions).
2.1.2 If several motors are switched on
❶
On the remote control, press
1
2
and
1
2
at the
same time and hold for 3 seconds, until the red
LED flashes. Release the buttons.
The remote control searches for the various motors.
The LED flashes red, then briefly green as soon as a
new motor is found.
❷
When the LED starts flashing red slowly, press
the
1
2
button as many times as required to
select the motor to be paired.
The corresponding shutter activates briefly.
❸
Once themotor has been found, press
1
2
.
❹
After a few seconds, the shutter activates twice
to confirm pairing.
❺
To exit pairing mode, press
1
2
for 3 seconds.
❻
Then proceed with the setting of the stops (see
motor instructions).
