EN
16
17
> 3s
> 3s
x 2
x 1
The motor has already been associated with a transmitter.
You can associate various transmitters from the X3D range (telephone transmitter,
other remote control, etc.) with the up/down function of the motor. Number of
transmitters that may be associated: 16 max.
To associate these transmitters, please consult their instructions.
An additional user guide describing the operation of the TYMOOV motor with the
TYXIA 1712 and TYXIA 2330 remote controls is available on the website
www.deltadore.com.
The stops must first be removed then set again for them to be modified.
Remove them by proceeding as follows:
See section 4.2 “setting stops” to set them again.
5/ Modifying stops
6/ Associating another transmitter
> 3s
x 2
The motor
will be activated briefly.
twice.
Press button B on the front
panel of the remote control,
until the LED flashes green.
On the transmitter, press and hold
the
et
buttons at
the same time for more than 3
seconds until the LED comes on.
The stops will now be
removed
The new
remote control
will now be
associated with the
motor
On the transmitter that is already
associated, press the
button for more than 3 seconds
until the motor is activated briefly.
Validate on the transmitter to be
associated (e.g. new remote control)
On the new remote control,
press the
and
buttons at the same time for
more than 3 seconds until the
LED comes on.
The motor will briefly
be activated twice.
You want to control the opening of roller shutters in the event that smoke is
detected.
Motor type
Linking to a wireless smoke detector
TYMOOV xRP2 and DxRP2
Wireless smoke detector directly linked to the motor
TYMOOV xRE2
(Version > S02.04.00)
Wireless smoke detector directly linked to the motor
TYMOOV xRE2
(Version < S02.04.00)
Only by linking your motor and the wireless smoke detector to a
TYXAL+ alarm system
To find out the type and version of the motor, consult the «Troubleshooting»
chapter.
7/ Linking a smoke detector directly to the
motor
> 3s
x 2
x 1
When the motors have been associated via a bidirectional grouped command, they
will start up at slightly staggered time intervals (100 ms) in order to limit the peak
current in the electric line during start-up.
• If the motors were associated at the same time in a grouped command, they will
start up in the order in which they were detected during the association process.
E.g. It could be that one lounge motor starts first, followed by a bedroom motor,
then the second lounge motor. There may be a time lapse between the first and
second lounge motors starting.
• If you would like the motors to start in a specific order, you should associate them
one by one in the order you require.
Refer to the user guide for each remote control.
E.g. If you have 3 roller shutter motors in one lounge, associate them one by one
with the remote control so that they start up without a big time lapse.
8/ Grouped command
On the transmitter that is already
associated, press the
button for
more than 3 seconds until the motor is
activated briefly.
Briefly press the button of the detector.
The motor will briefly be activated
twice.
