EN
18
19
10/ Remove one or several associations
10.1 Remove the remote control association with
the motor
- Remove the front panel of the remote control.
- Press button A.
The LED will flash red.
- Press
as many times as required to select the motor (receiver) to remove.
- Press the
button.
The motor will be activated briefly
- Press button A to exit.
10.2 Remove all associations
- Remove the front panel of the remote control.
- Press button A.
The LED will flash red.
- Press the
and
buttons at the same time and hold for 3 seconds.
The motor will be activated briefly
- Press button A to exit.
All the associated motors will be removed.
9/ Obstacle detection
The motors of the TYMOOV range include the obstacle detection feature.
It fully protects the roller shutter mechanism.
After locking on an obstacle, the motor reverses direction by about 15 cm.
Obstacles can only be detected when the stops have been set.
9.1 Setting of the obstacle detection type
For Radio Performance xRP2 and DxRP2 motors, you have a choice between two
detection modes:
- Detection:
(default mode), more efficient obstacle detection, preventing
the apron from unwinding in the casing.
- Basic Detection:
detection of obstacles with unwinding of the apron in the casing.
Repeat the operations above to switch between modes.
The Radio Efficacité xRE2 motor only has Basic obstacle detection.
> 3s
x 2
Press button B on the front
panel of the remote control,
until the LED flashes green.
On the transmitter, press together
and hold down the .
and
buttons for more than 3
seconds until the LED comes on.
The motor operates briefly:
once = Detection
(default setting)
twice = Basic Detection
9.2 Adjustment of the sensitivity of obstacle detection
for Basic detection (only)
If an inadvertent obstacle is detected, you can reduce the detector’s sensitivity to
the obstacle.
Repeat the operations above to switch between modes.
> 3s
x 2
Press button B on the front
panel of the remote control,
until the LED flashes green.
On the transmitter, press and
hold the
button for
more than 3 seconds until the
LED turns on.
The motor will be
activated briefly:
Once = high sensitivity
Twice = low sensitivity
