EN
14
15
3/ Stop settings
Press and hold the
button until the shutter is in the required
position.
Upward slow mode (step by step) with the following
sequence of buttons:
O
O
(at <1 second intervals), then long press on
until the shutter reaches the required position.
Press the following button sequence:
O
O
O
(at <1 second intervals), then long press on
.
The motor briefly starts twice.
❶
Manual upper stop
❸
Manual lower stop
❹
Setting the lower stop
3.4 Setting 2 manual stops
x 2
x 1
x 2
x 1
4/ Clearing stops
4.1 By wiring
- Switch off the power supply to the system.
- Connect the black and brown wires to
the raise phase and set the switch to the
‘raise’ position.
- Switch on the system’s power supply
again for less than 10 seconds until the
motor makes 2 movements (forwards/
backwards).
- Switch off the power supply to the
system again.
- Reconnect the black and brown wires as
they were initially (see § Connection).
- Switch on the power supply to the system again.
The stops have now been cleared. You can store them over again.
4.2 By the inverter (2 options)
4.2.1 From the lower position
- Lower the shutter completely,
- Press
O
(STOP) within 5 seconds following the stop of the shutter,
- Then perform the following sequence:
O
O
(at <3 second intervals), then long press on .
The motor briefly starts twice.
The 2 stops have now been cleared.
OR
4.2.2 From the upper position
- Raise the shutter completely,
- Press
O
(STOP) within 5 seconds following the stop of the shutter,
- Then perform the following sequence:
O
O
(at <3 second intervals), then long press on .
The motor briefly starts twice.
The 2 stops have now been cleared.
3 x 0.75 mm
2
2 x 1.5 mm
2
L
L
N
N
Black
Brown
Blue
Power supply
230 V, 50 Hz
Single-phase
Press and hold the button until the shutter is in the required
position.
Upward slow mode (step by step) with the following
sequence of buttons:
O
O
(at <1 second intervals), then long press on
until
the shutter reaches the required position.
Press the following button sequence:
O
O
(at <1 second intervals), then long press on
.
The motor briefly starts once.
❷
Setting the upper stop
