EN
8
9
1/ Motor fitting
• Never hit the motor head or output shaft to fit the motor into the tube.
Never pierce the tube when the motor is installed.
• To attach the apron, use screws that do not enter the tube
by more than 1 mm.
1.1 Crown and wheel assembly
1.2 Assembly in the tube
For attachment and driving accessories as well as mechanical parts,
consult our catalogue.
Model
Length for drilling (L)
Total length
TYMOOV 6Nm, 10 Nm and
20 Nm
395 mm
422 mm
Tube
L: length for drilling wheel
attachment by screws or rivet
1.3 Motor head position
The motor head must be positioned on the mount such that the cable outlet is in
the lower part when seen horizontally.
1.4 Attaching the motor to the mount
Push the tube/motor (A) onto the mount (B) until it locks into place (click).
8
NO
8
NO
8
NO
4
OK
4
OK
4
OK
Cable
1
2
Crown
Motor head
Wheel
“Click”
(A)
(B)
“Click”
Ensure that you create a loop in the
power cable to prevent water entering
the motor
It is strictly prohibited to
screw into the motor head.
