10
11
EN
5/
Configuration
This menu is used to determine all the settings adapted to your installation.
❶
To enter configuration mode, press the
MODE
button for 10 seconds until the
screen displays
CF01
.
❷
Press
+
or
-
to set.
❸
Briefly press
MODE
to go to the next menu.
Press
MODE
or wait 5 seconds to exit.
CF01 - Correcting the temperature measured
Setting from -5°C to +5°C
Example:
If the temperature displayed by the unit is 15°C and the actual
temperature (thermometer) is 16°C, set +1°C.
CF02 - Settings lock
0
No locking (default setting)
1
Total locking
2
Partial locking. Modification of the temperature setting at +/-2°C
The screen will display ‘____’ if it is locked
To unlock (selection 1 and 2), simultaneously press + or - the buttons for 10
seconds.
CF04 - Frost protection mode temperature setting
Setting of 5°C to 15°C. Default value: 10°C.
CF05 - Type of temperature displayed in AUTO mode
0
Temperature setting display (default selection)
1
Display of the measured room temperature.
1: Pressing the + or - button once displays and sets the temperature setting (in
ON
mode).
CF06 - Regulation time base
15
15 minutes (default settings)
30
30 minutes
45
45 minutes
60
60 minutes
On/Off
On/Off
CF07 - Modification of the on/off regulation hysteresis
Only displayed if menu CF06 = on/off
Setting of 0.2°C to 2°C. Default value: 0.4°C
CF08 - Anti-seize function
The Anti-seize function activates the circulator 1 minute per day to prevent any
seizing up during a non-heating period.
0
Anti-seize disabled
1
Anti-seize enabled (default settings)
