Signal inputs
Digital Projection E-Vision 4000 Series
EDID on the HDMI, and HDBaseT inputs
If you are using a computer graphics card or another source that obeys the EDID protocol, the source will automatically configure itself to suit the capability of the
projector.
Otherwise refer to the documentation supplied with the source to manually set the resolution to the DMD™ resolution of the projector or the nearest suitable
setting. Switch off the source, connect to the projector, then switch the source back on again.
Using HDMI / HDBaseT switchers with the projector
When using a HDMI/HDBaseT source switcher with the projector, it is important to set the switcher so that it passes the projector EDID through to the source
devices.
If this is not done, the projector may not be able to lock to the source or display the source correctly as its video output timings may not be compatible with those of
the projector. Sometimes this is called transparent, pass-through or clone mode. See your switcher’s manual for information on how to set this mode.
EDID
EDID
EDID
EDID
1
2
3
The EDIDs in the switcher should be the same as the one in the projector.
1. Sources
2. Switcher
3. Projector
Connection Guide
Rev A December 2021
page 35
Notes
