Operating the projector
Digital Projection E-Vision 4000 Series
Interlock reset
In the event of the laser illumination turning off as a result of an Interlock break:
1. Make sure all interlocks are in place. See Interlock Switches on page 15
2. Turn ON the laser illumination. See Switching the projector on on the previous page
Selecting an input signal
Please refer to the connection
guide for details about connecting a
signal source. See Signal inputs on
page 34
1. Connect one or more image sources to the projector.
2. Select the input you want to display:
l
Press one of the input buttons on the remote control.
l
Press
SOURCE
on the remote control or control panel. Use the
UP
and
DOWN
navigation buttons to select the input source in the
SOURCE
menu.
Press
ENTER
to confirm your choice.
Selecting a test pattern
This projector is able to display a grid test pattern.
Use one of the following methods to display a test pattern:
1. Press
MENU
on the remote or control panel to open the OSD.
2. Use the
LEFT
and
RIGHT
arrow buttons to access the
Input
menu.
3. Use the
UP
,
DOWN
and
RETURN
buttons to access the
Test Pattern
sub menu.
4. Use the
LEFT
and
RIGHT
arrow buttons to select the Grid test pattern.
To return to the main image, set the test pattern to Off and press
MENU
to exit the OSD.
Installation & QuickStart Guide
Rev A December 2021
page 29
Notes
