background image

4

Pressure regulators, rubber tubes and clips

CHECK that tubing is completely over the nozzles at each end of
the tubing and that it is held firmly in place by tube clips (See
fig.9).Check the expiry date and state of the rubber tube regularly.
If it is past its expiry date or has been damaged, replace it with
one which complies with the current regulations. 
When connecting the pressure regulator to the gas bottle avoid
undue twisting of the flexible tubing.

This heater must be used with an approved Low Pressure Regulator which complies with 
SAB S1237. The regulator is required to reduce the pressure of the gas in the cylinder from about
700 kPa to about 2,8 kpa to operate the radiant - the  heating panels).

Ventilation

USE ONLY IN A WELL VENTILATED ROOM

Adequate ventilation must be provided in rooms in which the heater is used. This ensures
removal of the products of combustion and allows the entry of replacement air.
The following table shows the smallest size of room suitable for each heat setting and the
dimensions of the aperture which  must be provided equally divided between high and low
level, according with the maximum, medium or minimum power.

Safety guard

The guard is to prevent risk of fire and no part of it should be permanently removed.

It does not give full protection for young children or the infirm.

OPERATING INSTRUCTIONS

Lighting the heater

1. Open the gas bottle tap.
2. Fully depress the large knob on the valve for 10 seconds and then turn it 90° to the right

or left to activate the piezoelectric starter (if the pilot flame does not ignite return the
knob to the initial position and repeat the operation). Continue to hold the knob down
for a further 20 seconds to allow the thermocouple to heat up, then release the knob. 
Turn the small thermostat knob anticlockwise to po, to ignite the 3 burners.  
When the room has reached the desired temperature, turn the thermostat knob clockwise
until the 2 burners on the left go off. In this way, the appliance will automatically main-
tain the set temperature by cycling between maximum output (3 burners) and minimum
output (1 burner) and vice-versa.
In the event of “burn back” turn off and try again. Should it happen a second time,
return the unit to the dealer.

fig. 9

Room Size

Room Aperture

105 cm

2

42 m

3

GB-5721009200  4-12-2003  12:08  Pagina 4

Reviews: