3
1) Place the gas cylinder in the gas cylinder compartment
and connect the regulator to the cylinder as shown on
page 3.
2) To fit the backcover, insert the two tabs located on the
left-hand side of the backcover into the corresponding
slots in the cabinet. Then insert the tab on the right hand
side into its slot.
IMPORTANT:
to remove the backcover, lift the back-
cover and pull clear of the slots.
Gas cylinder
compartment
Tabs
Slot
ASSEMBLY
GENERAL SAFETY INSTRUCTIONS - Gas bottle
Gas Bottle with 9 kg of maximum capacity can be installed. Changing of gas bottle must not
be carried out in the presence of a naked flame. Use the gas bottle always in upright posi-
tion.MAKE SURE the black neoprene “O -Ring Seal is in place or the regulator bullnose.
Regularly examine, and if unduly compressed or damaged, replace. Support regulator with one hand
while aligning the regulator bullnose (threaded part) with the threaded gas outlet on cylinder valve.
Screw regulator handwheel ANTICLOCKWISE (LEFT HAND THREAD) into gas outlet. Tighten regula-
tor handwheel as ttight as possible by hand only. DO NOT USE TOOLS OR LEVERS TO TIGHTEN.
When connecting the regulator to the gas cylinder, avoid undue twisting of the flexible hose.
To place the bottle in position, remove the rear panel; than put the bottle in position and
replace the panel.
PLACE teh cylinder in the heater cabinet so that the cylinder valve is facing into the compartment.
Take care to ensure that is positioned in such a way that the flexible hose does not come
into contact with the metal panels of the heater, and avoid twisting of the flexible hose.
OPEN cylinder valve by turning handwheel ANTICLOCKWISE. Now refer to the lighting
instruction on the heater itself. Please read carefully and follow the instructions.
Do not turn the bottle upside down to use completely its content.
GB-5721009200 4-12-2003 12:08 Pagina 3
