4
heater. Plugging heater into a worn outlet /receptacle/ may result in overheating of the power
cord or fire.
17. Do not use an extension cord because the extension cord may overheat and cause a risk
of fire. However, if you have to use an extension cord, the cord shall be Ul listed No. 1 4 AWG
minimum size and rated not less than 1 875 watts, ISAMP at 125 V and has to be used only
for supplying power to this heater.
18. Be sure that the plug is fully inserted into an appropriate receptacle. Please remember that
receptacles also deteriorate due to aging and continuous use: check periodically if signs
overheating or deformations are evidenced by the plug. Do not use the receptacle and CALL
your electrician.
19. Check that neither the appliance nor the power cable have been damaged in any way
during transportation.
20. Before connecting to electric power outlet, check your electrical power supply. It must be
120 volts A.C. (alternating current). The outlet may be 15 amp. or 20 amp. The circuit must
be of adequate size and must be protected by fuse or circuit breacker. DO NOT place heater
directly beneath electrical receptacle and DO NOT place heater against paper board or low
density fiberboard.
DO NOT touch hot surfaces.
DO NOT immerse cord, plug or heater in water or othet liquid, or pour this will cause
dangerous electrical conditions and potential electrical shock.
DO NOT obstruct the top or bottom air openings.
Dust and lint on the heating element can obstruct the free flow of air. DO NOT operate when
so obstructed.
Operating with air openings obstructed could cause a dangerous condition.
22. Make sure that no pieces of polystyrene or other packaging material have been left into the
appliance. It may be necessary to pass over the appliance with a wacuum cleaner.
23. When switching on the appliance for the first time, allow it to run at full power for about 1
hours to get rid of the unpleasant smell. Make sure that the room in which the appliance is
located is well ventilated during this operation.
24. It is not advisable for the appliance to be positioned where it is exposed to draughts which
might prevent it from working properly.
SAVE THESE INSTRUCTIONS
