Steps
1. Adhere the magnet and the metal bar to the battery.
NOTE:
Install the magnet and the metal bar from the faulty battery.
2. Align the screw holes on the battery with the screw holes on the system board and palm-rest assembly.
3. Replace the two screws (M1.2x4) that secure the battery to the system board.
4. Replace the seven screws (M1.6x3) that secure the battery to the palm-rest assembly.
5. Place the interposer board to the connector on the system board.
NOTE:
The interposer board is not polarity sensitive and both sides are compatible.
6. Connect the battery cable to the interposer board.
7. Replace the Torx 5 screw (M1.6x3.4) that secures the battery cable to the system board.
Next steps
1. Install the
.
2. Follow the procedure in
After working inside your computer
.
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in
Before working inside your computer
.
2. Remove the
3. Remove the
.
About this task
The following images indicate the location of display assembly and provide a visual representation of the removal procedure.
16
Removing and installing components
Summary of Contents for XPS 13 7390 2-in-1
Page 1: ...XPS 13 7390 2 in 1 Service Manual Regulatory Model P103G Regulatory Type P103G001 ...
Page 10: ...10 Removing and installing components ...
Page 11: ...Removing and installing components 11 ...
Page 25: ...Removing and installing components 25 ...
