Dell USC, User Manual

Page: 65 / 132

USC and USC-LCE Operations
65
IPv6 Configuration
To set IPv6 configuration:
1 From IP Configuration , select IPV6 , and enable or disable the protocol.
2 Specify the IP Address Source .
3 Specify user-configured settings for alternate Ethernet IP Address.
4 Click Next to save your settings and proceed.
To specify user-configured controls, click Ethernet IP Address settings, and
enter appropriate values for the following:
•
Ethernet IP Address
— Maximum value of
FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF.
–
The multi-cast (ff00:/8) and loopback (::1/128) values are not valid
addresses for the Ethernet IP address and/or the other address related
fields described in this section.
– IPv6 Address forms supported:
•
X:X:X:X:X:X:X:X
— In this form,
X
represents the hexadecimal
values of the eight 16-bit pieces of the address. You can omit
leading zeros in individual fields, but you must include at least
one numeral in every field.
Attribute Description Values
IPv6 iDRAC NIC IPv6 protocol support. Disabling IPv6
deactivates the remaining controls
Enable or
Disable
IP Address
Source
The ability of the iDRAC NIC to acquire an IPv6
address from the DHCP server.
Disabling
IP Address Source deactivates the Ethernet
IP Address , Prefix Length , and Default Gateway
controls.
Enable or
Disable