Adding and Replacing Parts
67
NOTICE:
When the hard drive is not in the computer, store it in protective
antistatic packaging. See "Protecting Against Electrostatic Discharge" on
page 13.
8
Use a screwdriver to remove the four black, numbered screws holding
the hard drive in place in the upper side of the empty module bay.
9
Pull straight out on the pull-tab located at the front of the hard drive;
pull the hard drive out of its connector and lift the hard drive out of
its bay.
10
Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
11
Line up the connectors on one end of the new drive with the
connectors at the rear of the hard drive bay. At an angle of
approximately 30 degrees, gently push the new hard drive into place.
screw (4)
hard drive
hard drive
pull-tab
7T097bk1.book Page 67 Thursday, September 26, 2002 6:47 AM
