Dell S6100, Configuration Manual

Page: 807 / 1743

Version Description
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information The following describes the
show ip route summary
shown in the following example.
Column Heading Description
Route Source Identifies how the route is configured in Dell Networking OS.
Active Routes Identifies the best route if a route is learned from two protocol sources.
Non-active Routes Identifies the back-up routes when a route is learned by two different protocols. If the
best route or active route goes down, the non-active route becomes the best route.
ospf 100 If routing protocols (OSPF, RIP) are configured and routes are advertised, then
information on those routes is displayed.
Total 1388 active... Displays the number of active and non-active routes and the memory usage of those
routes. If there are no routes configured in the Dell Networking OS, this line does not
appear.
Example
Dell> show ip route summary
Route Source Active Routes Non-active Routes
connected 17 0
static 3 0
ospf 100 1368 2
Intra-area: 762 Inter-area: 1 External-1: 600 External-2: 5
Total 1388 2
Total 1388 active route(s) using 222440 bytes
Total 2 non-active route(s) using 128 bytes
Dell>
Related Commands
• show ip route — display information about the routes found in the switch.
show ip traffic
View IP, ICMP, UDP, TCP and ARP traffic statistics.
Syntax show ip traffic [all | cp | rp1 | rp2]
NOTE: These options are supported only on the E-Series.
Parameters
all (OPTIONAL) Enter the keyword all to view statistics from all processors. If you do not
enter a keyword, you also view all statistics from all processors.
cp (OPTIONAL) Enter the keyword
cp
to view only statistics from the Control Processor.
IPv4 Routing 807