Usage Information
When you configure the
dot1x server-timeout
value, take into account the communication medium used to
communicate with an authentication server and the number of RADIUS servers configured. Ideally, the
dot1x
server-timeout
value (in seconds) is based on the configured RADIUS-server timeout and retransmit values
and calculated according to the following formula:
dot1x server-timeout
seconds
> (radius-server
retransmit
seconds
+ 1) * radius-server timeout
seconds
.
Where the default values are as follows:
dot1x server-timeout
(30 seconds), radius-server retransmit (3
seconds), and radius-server timeout (5 seconds).
Example
Dell(conf)# radius-server host 10.11.197.105 timeout 6
Dell(conf)# radius-server host 10.11.197.105 retransmit 4
Dell(conf)# interface tengigabitethernet 1/1/1/1
Dell(conf-if-te-1/1/1/1)# dot1x server-timeout 40
dot1x static-mab
Enable static MAC authorization bypass (MAB) and configure static MAB profile to an interface.
Syntax
[no] dot1x static-mab profile
profile-name
Parameters
profile
profile-name
Enter the keyword
profile
and the
profile-name
to configure the static MAB profile
name. The profile name length is limited to 32 characters.
Defaults
Disabled.
Command Modes
INTERFACE
INTERFACE (BATCH MODE)
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant
Dell
Networking OS Command Line Reference Guide
.
Version
Description
9.10(0.0)
Introduced on the S3100 series, S4048–ON, S4048–ON, S4810, S4820T, S5000, S6000,
S6000–ON, S6100–ON, the Configuration Terminal Batch mode on C9010, Z9100–ON,
and Z9500.
9.9(0.0)
Introduced on the C9010.
Usage Information
The
dot1x static-mab
command enables static MAB (mac auth bypass) and configures the associated profile
on a dot1x interface. Static MAB bypasses the authentication server for the supplicant MAC addresses configured
in the associated profile.
Before you enable static MAB, you must do the following:
•
Enable MAC authentication bypass on the port by configuring the
dot1x mac-auth-bypass
command.
•
Ensure that no configured profile exists at the time of configuring the
static-mab
command.
•
Use this command in Interface Batch Mode to enable static MAB in a dual-homing setup.
Example
Dell(conf)#do show dot1x interface ten gigabit ethernet 0/41
802.1x information on Te 0/41:
----------------------------------------
802.1X
171
