Version
Description
9.4.(0.0)
Introduced on the S-Series and Z9000.
Usage Information
When you use this command, the management ports corresponding to both the active unit and the standby unit
are associated with the management VRF.
maximum dynamic-routes
Specify the maximum number of dynamic (protocol) routes a VRF can have.
Syntax
maximum dynamic-routes
limit
{warn-threshold
threshold-value
| warning-only}
To remove the limit on the maximum number of routes used, use the
no maximum dynamic-routes
command.
Parameters
limit
Maximum number of routes allowed in a VRF. The valid range is from 1 to 320,000 (or
maximum allowable for that platform if a smaller value).
warning-threshold
The warning threshold value is a percentage of the limit value. When the number of
routes reaches the specified percentage of the limit, a warning message appears. The
valid range is from 1 to 100.
After the limit is reached, additional dynamic routes are not allowed.
warning-only
When you use the
warning-only
option, when the maximum number of dynamic
routes reaches the limit, a warning message appears.
After the limit is reached, additional dynamic routes are still allowed.
Defaults
No limit is set on the maximum number of dynamic routes for a VRF.
Command Modes
CONFIGURATION-VRF
CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
Command Line Reference Guide
.
Version
Description
9.10(0.0)
Introduced on the S6100–ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON and Z9500.
9.4(0.0)
Introduced on the S–Series.
Usage Information
If you do not specify the maximum route limit for a VRF, the VRF has unlimited space that extends to the maximum
number of entries allowed for the system.
Virtual Routing and Forwarding (VRF)
1659
