Parameters
percentagedecimal
_value
in | out
Enter the percentage of broadcast traffic allowed in or out of the network. Optionally, you
can designate a decimal value percentage, for example, 55.5%. The decimal range is
from .1 to .9.
wred-profile name
Enter the keyword
wred-profile
followed by the profile name to designate a wred-profile.
packets_per_secon
d
in
Enter the packets per second of broadcast traffic allowed into the network. The range is
from 0 to 33554368.
Defaults
none
Command Modes
CONFIGURATION (conf)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Version
Description
9.10(0.0)
Introduced on the S6100–ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.2(0.0)
Introduced on the M I/O Aggregator. This command is supported in Programmable-MUX
(PMUX) mode only.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
7.4.1.0
E-Series Only: Added the
percentage decimal value
option.
6.5.1.0
Introduced on the E-Series.
Usage Information
Broadcast storm control is valid on Layer 2/Layer 3 interfaces only. Layer 2 broadcast traffic is treated as
unknown-unicast traffic.
storm-control broadcast (Interface)
Configure the percentage of broadcast traffic allowed on an interface (ingress only).
Syntax
storm-control broadcast [
packets_per_second
in]
To disable broadcast storm control on the interface, use the
no storm-control broadcast
[
packets_per_second
in]
command.
1558
Storm Control
