To exit RSTP mode, use the
exit
command.
Defaults
Not configured
Command Modes
CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Version
Description
9.10(0.0)
Introduced on the S6100-ON.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
6.2.1.1
Introduced on the E-Series.
Usage Information
RSTP is not enabled when you enter RSTP mode. To enable RSTP globally on the system, use the
no disable
command from RSTP mode.
Example
Dell(conf)# protocol spanning-tree rstp
Dell(config-rstp)# no disable
Related Commands
•
— disables RSTP globally on the system.
show config
View the current configuration for the mode. Only non-default values are displayed.
Syntax
show config
Command Modes
CONFIGURATION RSTP (conf-rstp)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Version
Description
9.10(0.0)
Introduced on the S6100-ON.
9.8(1.0)
Introduced on the Z9100-ON.
1368
Rapid Spanning Tree Protocol (RSTP)