Dell S4820T, Configuration Manual

Page: 761 / 1178

x - Dot1x untagged, X - Dot1x tagged
o - OpenFlow untagged, O - OpenFlow tagged
G - GVRP tagged, M - Vlan-stack
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT tagged
NUM Status Description Q Ports
* 1 Inactive
R 100 Active T Fo 1/20
R 300 Active T Fo 1/24
Configuring the Sample Remote Port Mirroring
Remote port mirroring requires a source session (monitored ports on different source switches), a
reserved tagged VLAN for transporting mirrored traffic (configured on source, intermediate, and
destination switches), and a destination session (destination ports connected to analyzers on destination
switches).
Configuration Steps for RPM
Step Command Purpose
1 configure terminal Enter global configuration mode.
2
monitor session <id> type rpm The <id> needs to be unique and not already defined
in the box specifying type as 'rpm' defines a RPM
session.
3 source Interface | Range Specify the port or list of ports that needs to be
monitored
4
direction Specify rx, tx or both in case to monitor ingress/
egress or both ingress and egress packets on the
specified port..
5 rpm source-ip <id> dest-ip <id> Specify the source ip address and the destination ip
where the packet needs to be sent.
6
<no> flow-based enable Specify flow-based enable for mirroring on a flow by
flow basis and also for vlan as source.
7
no enable (Optional) No disable command is mandatory in
order for a rpm session to be active.
Configuring the sample Source Remote Port Mirroring
Dell(conf)#interface vlan 10
Dell(conf-if-vl-10)#mode remote-port-mirroring
Dell(conf-if-vl-10)#tagged te 1/4
Dell(conf-if-vl-10)#exit
Dell(conf)#monitor session 1 type rpm
Dell(conf-mon-sess-1)#source te 1/5 destination remote-vlan 10 dir rx
Dell(conf-mon-sess-1)#no disable
Dell(conf-mon-sess-1)#exit
Dell(conf)#inte vlan 100
Dell(conf-if-vl-100)#tagged te 1/7
Dell(conf-if-vl-100)#exit
Dell(conf)#interface vlan 20
Dell(conf-if-vl-20)#mode remote-port-mirroring
Port Monitoring
761