Dell S4820T, Configuration Manual

Page: 379 / 1178

For more information, refer to the SSH Server and SCP Commands section in the Security chapter of the
Dell Networking OS Command Line Reference Guide .
Monitoring FIPS Mode Status
To view the status of the current FIPS mode (enabled/disabled), use the following commands.
• Use either command to view the status of the current FIPS mode.
show fips status
show system
Examples of the
show fips status
and
show system
Commands
The following example shows the
show fips status
command.
Dell#show fips status
FIPS Mode : Enabled
for the system using the show system command.
The following example shows the
show system
command.
Dell#show system
Stack MAC : 00:01:e8:8a:ff:0c
Reload Type : normal-reload [Next boot : normal-reload]
-- Unit 0 --
Unit Type : Management Unit
Status : online
Next Boot : online
Required Type : S4810 - 52-port GE/TE/FG (SE)
Current Type : S4810 - 52-port GE/TE/FG (SE)
Master priority : 0
Hardware Rev : 3.0
Num Ports : 64
Up Time : 7 hr, 3 min
Dell Networking OS Version : 4810-8-3-7-1061
Jumbo Capable : yes
POE Capable : no
FIPS Mode : enabled
Burned In MAC : 00:01:e8:8a:ff:0c
No Of MACs : 3
...
Disabling FIPS Mode
When you disable FIPS mode, the following changes occur:
• The SSH server disables.
• All open SSH and Telnet sessions, as well as all SCP and FTP file transfers, close.
• Any existing host keys (both RSA and RSA1) are deleted from system memory and NVRAM storage.
FIPS Cryptography
379