bgp graceful-restart [restart-time
time-in-seconds
]
The default is
120 seconds
.
• Set maximum time to retain the restarting peer’s stale paths.
CONFIG-ROUTER-BGP mode
bgp graceful-restart [stale-path-time
time-in-seconds
]
The default is
360 seconds
.
• Local router supports graceful restart as a receiver only.
CONFIG-ROUTER-BGP mode
bgp graceful-restart [role receiver-only]
Enabling Neighbor Graceful Restart
BGP graceful restart is active only when the neighbor becomes established. Otherwise, it is disabled.
Graceful-restart applies to all neighbors with established adjacency.
With the graceful restart feature, Dell Networking OS enables the receiving/restarting mode by default. In
Receiver-Only mode, graceful restart saves the advertised routes of peers that support this capability
when they restart. This option provides support for remote peers for their graceful restart without
supporting the feature itself.
You can implement BGP graceful restart either by neighbor or by BGP peer-group. For more information,
refer to the
Dell Networking OS Command Line Interface Reference Guide
.
• Add graceful restart to a BGP neighbor or peer-group.
CONFIG-ROUTER-BGP mode
neighbor {
ip-address
|
peer-group-name
} graceful-restart
• Set the maximum restart time for the neighbor or peer-group.
CONFIG-ROUTER-BGP mode
neighbor {
ip-address
|
peer-group-name
} graceful-restart [restart-time
time-
in-seconds
]
The default is
120 seconds
.
• Local router supports graceful restart for this neighbor or peer-group as a receiver only.
CONFIG-ROUTER-BGP mode
neighbor {
ip-address
|
peer-group-name
} graceful-restart [role receiver-only]
• Set the maximum time to retain the restarting neighbor’s or peer-group’s stale paths.
CONFIG-ROUTER-BGP mode
neighbor {
ip-address
|
peer-group-name
} graceful-restart [stale-path-time
time-in-seconds
]
The default is
360 seconds
.
230
Border Gateway Protocol IPv4 (BGPv4)
Summary of Contents for S4820T
