Dell S4048T, Configuration Manual

Page: 568 / 1277

Changing the IS-Type
To change the IS-type, use the following commands.
You can configure the system to act as a Level 1 router, a Level 1-2 router, or a Level 2 router.
To change the IS-type for the router, use the following commands.
• Configure IS-IS operating level for a router.
ROUTER ISIS mode
is-type {level-1 | level-1-2 | level-2-only}
Default is level-1-2 .
• Change the IS-type for the IS-IS process.
ROUTER ISIS mode
is-type {level-1 | level-1-2 | level-2}
Example of the
show isis database
Command to View Level 1-2 Link State Databases
To view which IS-type is configured, use the
show isis protocol
command in EXEC Privilege mode. The
show config
command in ROUTER ISIS mode displays only non-default information. If you do not change
the IS-type, the default value ( level-1-2 ) is not displayed.
The default is Level 1-2 router. When the IS-type is Level 1-2, the software maintains two Link State databases,
one for each level. To view the Link State databases, use the
show isis database
command.
Dell#show isis database
IS-IS Level-1 Link State Database
LSPID LSP Seq Num LSP Checksum LSP Holdtime ATT/P/OL
B233.00-00 0x00000003 0x07BF 1088 0/0/0
eljefe.00-00 * 0x00000009 0xF76A 1126 0/0/0
eljefe.01-00 * 0x00000001 0x68DF 1122 0/0/0
eljefe.02-00 * 0x00000001 0x2E7F 1113 0/0/0
Force10.00-00 0x00000002 0xD1A7 1102 0/0/0
IS-IS Level-2 Link State Database
LSPID LSP Seq Num LSP Checksum LSP Holdtime ATT/P/OL
B233.00-00 0x00000006 0xC38A 1124 0/0/0
eljefe.00-00 * 0x0000000D 0x51C6 1129 0/0/0
eljefe.01-00 * 0x00000001 0x68DF 1122 0/0/0
eljefe.02-00 * 0x00000001 0x2E7F 1113 0/0/0
Force10.00-00 0x00000004 0xCDA9 1107 0/0/0
Dell#
Controlling Routing Updates
To control the source of IS-IS route information, use the following command.
• Disable a specific interface from sending or receiving IS-IS routing information.
ROUTER ISIS mode
passive-interface interface
Intermediate System to Intermediate System 568