Dell S4048T-ON, Configuration Manual

Page: 907 / 1146

The following example shows how to configure two new switches for stacking using 10G ports.
Dell-1(conf)#stack-unit 1 stack-group 0
Setting ports Te 1/1 Te 1/2 Te 1/3 Te 1/4 as stack group will make their interface configs
obsolete after
a reload.
[confirm yes/no]:yes
Dell-2(conf)#stack-unit 1 stack-group 0
Setting ports Te 1/1 Te 1/2 Te 1/3 as stack group will make their interface configs obsolete
after
a reload.
[confirm yes/no]:yes
Dell-1#show system stack-ports
Topology: Ring
Interface Connection Link Speed Admin Link Trunk
(Gb/s) Status Status Group
------------------------------------------------------------------
1/1 1/1 10 up up
1/2 1/2 10 up up
1/3 1/3 10 up up
1/4 1/4 10 up up
Add Units to an Existing Stack
You can add units to an existing stack in one of three ways.
• By manually assigning a new unconfigured unit a position in an existing stack.
• By adding a configured unit to an existing stack.
• By merging two stacks.
If you are adding units to an existing stack, you can either:
• allow Dell Networking OS to automatically assign the new unit a position in the stack, or
• manually determine each units position in the stack by configuring each unit to correspond with the stack before connecting it.
• If you add a unit that has a stack number that conflicts with the stack, the stack assigns the first available stack number.
• If the stack has a provision for the stack-number that will be assigned to the new unit, the provision must match the unit type, or Dell
Networking OS generates a type mismatch error.
After the new unit loads, it synchronizes its running and startup configurations with the stack.
Manually Assigning a New Unit to an Existing Stack
To manually assign a new unit a position in an existing stack, use the following steps.
1 On the stack, determine the next available stack-unit number, and the management priority of the management unit.
EXEC Privilege mode
show system brief
or
show system stack-unit
2 On the new unit, number it the next available stack-unit number.
EXEC Privilege mode
stack-unit stack-unit-number renumber stack-unit-new-number
3 (OPTIONAL) On the new unit, assign a management priority based on whether you want the new unit to be the stack manager.
CONFIGURATION mode
stack-unit stack-unit-number priority priority-number
Stacking 907