The default is the internal flash directory.
•
Specify a user name for all FTP users and configure either a plain text or encrypted password.
CONFIGURATION mode
ftp-server username
username
password [
encryption-type
]
password
Configure the following optional and required parameters:
•
username
: enter a text string.
•
encryption-type
: enter
0
for plain text or
7
for encrypted text.
•
password
: enter a text string.
NOTE:
You cannot use the
change directory (cd)
command until you have configured
ftp-server topdir
.
To view the FTP configuration, use the
show running-config ftp
command in EXEC privilege mode.
Configuring FTP Client Parameters
To configure FTP client parameters, use the following commands.
•
Enter the following keywords and the interface information:
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port[/subport] information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
•
For a Loopback interface, enter the keyword
loopback
then a number from 0 to 16383.
•
For a port channel interface, enter the keywords
port-channel
then a number.
•
For a VLAN interface, enter the keyword
vlan
then a number from 1 to 4094.
CONFIGURATION mode
ip ftp source-interface
interface
•
Configure a password.
CONFIGURATION mode
ip ftp password
password
•
Enter a username to use on the FTP client.
CONFIGURATION mode
ip ftp username
name
To view the FTP configuration, use the
show running-config ftp
command in EXEC privilege mode, as shown in the example for
Terminal Lines
You can access the system remotely and restrict access to the system by creating user profiles.
Terminal lines on the system provide different means of accessing the system. The console line (console) connects you through the console
port in the route processor modules (RPMs). The virtual terminal lines (VTYs) connect you through Telnet to the system. The auxiliary line
(aux) connects secondary devices such as modems.
80
Management
Summary of Contents for S4048T-ON
