Dell S4048T-ON, Configuration Manual

Page: 749 / 1146

Creating WRED Profiles
To create WRED profiles, use the following commands.
1 Create a WRED profile.
CONFIGURATION mode
wred-profile
2 Specify the minimum and maximum threshold values.
WRED mode
threshold
Applying a WRED Profile to Traffic
After you create a WRED profile, you must specify to which traffic Dell Networking OS should apply the profile.
Dell Networking OS assigns a color (also called drop precedence) — red, yellow, or green — to each packet based on it DSCP value before
queuing it.
DSCP is a 6–bit field. Dell Networking uses the first three bits (LSB) of this field (DP) to determine the drop precedence.
• DP values of 110 and 100, 101 map to yellow; all other values map to green.
• If you do not configure Dell Networking OS to honor DSCP values on ingress (refer to Honoring DSCP Values on Ingress Packets ), all
traffic defaults to green drop precedence.
• Assign a WRED profile to either yellow or green traffic.
QOS-POLICY-OUT mode
wred
Displaying Default and Configured WRED Profiles
To display the default and configured WRED profiles, use the following command.
• Display default and configured WRED profiles and their threshold values.
EXEC mode
show qos wred-profile
Displaying WRED Profiles
Example of the show qos wred-profile Command.
Dell#show qos wred-profile
Wred-profile-name min-threshold max-threshold max-drop-rate
wred_drop 0 0 100
wred_teng_y 467 4671 100
wred_teng_g 467 4671 50
wred_fortyg_y 467 4671 50
wred_fortyg_g 467 4671 25
Quality of Service (QoS) 749