Dell S4048T-ON, Configuration Manual

Page: 431 / 1146

• IP FIB
• L2 ACL
• L2 FIB
Clearing Interface Counters
The counters in the
show interfaces
command are reset by the
clear counters
command. This command does not clear the
counters any SNMP program captures.
To clear the counters, use the following the command.
• Clear the counters used in the
show interface
commands for all VRRP groups, VLANs, and physical interfaces or selected ones.
Without an interface specified, the command clears all interface counters.
EXEC Privilege mode
clear counters [ interface ] [vrrp [ vrid ] | learning-limit]
(OPTIONAL) Enter the following interface keywords and slot/port or number information:
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
• For a Loopback interface, enter the keyword
loopback
then a number from 0 to 16383.
• For the Management interface on the stack-unit, enter the keyword
ManagementEthernet
then the slot/port information.
• For a port channel interface, enter the keywords
port-channel
then a number.
• For a VLAN interface, enter the keyword
vlan
then a number from 1 to 4094.
• (OPTIONAL) To clear statistics for all VRRP groups configured, enter the keyword
vrrp
. Enter a number from 1 to 255 as the
vrid
.
• (OPTIONAL) To clear unknown source address (SA) drop counters when you configure the MAC learning limit on the interface,
enter the keywords
learning-limit
.
Example of the
clear counters
Command
When you enter this command, confirm that you want Dell Networking OS to clear the interface counters for that interface.
Dell#clear counters te 1/1
Clear counters on TenGigabitEthernet 1/1 [confirm]
Dell#
Interfaces 431