Dell S4048-ON, Configuration Manual

Page: 126 / 1039

CONFIGURATION mode
interface interface slot/port
2. Configure an IP address for the interface, placing it in Layer-3 mode.
INTERFACE mode
ip address ip-address
3. Apply an IP ACL to traffic entering or exiting an interface.
INTERFACE mode
ip access-group access-list-name {in} [implicit-permit] [vlan vlan-range | vrf vrf-
range]
NOTE: The number of entries allowed per ACL is hardware-dependent. For detailed specification about entries
allowed per ACL, refer to your line card documentation.
4. Apply rules to the new ACL.
INTERFACE mode
ip access-list [standard | extended] name
To view which IP ACL is applied to an interface, use the show config command in INTERFACE mode, or use the show
running-config
command in EXEC mode.
Example of Viewing ACLs Applied to an Interface
Dell(conf-if)#show conf
!
interface TenGigabitEthernet 1/1
ip address 10.2.1.100 255.255.255.0
ip access-group nimule in
no shutdown
Dell(conf-if)#
To filter traffic on Telnet sessions, use only standard ACLs in the
access-class
command.
Counting ACL Hits
You can view the number of packets matching the ACL by using the
count
option when creating ACL entries.
1. Create an ACL that uses rules with the count option. Refer to Configure a Standard IP ACL Filter .
2. Apply the ACL as an inbound or outbound ACL on an interface.
3.
show ip accounting access-list
EXEC Privilege mode
View the number of packets matching the ACL.
Configure Ingress ACLs
Ingress ACLs are applied to interfaces and to traffic entering the system.
These system-wide ACLs eliminate the need to apply ACLs onto each interface and achieves the same results. By localizing target
traffic, it is a simpler implementation.
To create an ingress ACL, use the
ip access-group
command in EXEC Privilege mode. The example shows applying the ACL,
rules to the newly created access group, and viewing the access list.
126
Access Control Lists (ACLs)