Dell PS-M4110, Installation Manual

Page: 43 / 70

37
Dell EqualLogic PS-M4110 Installation Guide Using the EqualLogic Setup Utility to Configure the Array
EXAMPLE - Using the Setup Utility
Login: grpadmin
Password: xxxxxxxx
The setup utility establishes the initial network and storage configuration for a storage array
and then configures the array as a member or a new or existing group of arrays.
For help, enter a question mark (?) at a prompt.
Welcome to Group Manager
Copyright 2011 Dell, Inc.
It appears that the storage array has not been configured.
Would you like to configure the array now? (y/n) [n]
y
Group Manager Setup Utility
Do you want to proceed (yes | no) [no]?
yes
Initializing. This may take several minutes to complete.
Enter the network configuration for the array:
Member name []:
member1
Network interface [eth0]: eth0
IP address for network interface []: 192.17.2.41
Netmask [255.255.255.0]:
Default gateway [192.17.2.1]:
Enter the name and IP address of the group that the array will join.
Group name []:
group1
Group IP address []: 192.17.2.20
Searching to see if the group exists. This may take a few minutes.
The group does not exist or currently cannot be reached. Make sure you have entered the correct
group IP address and group name.
Do you want to create a new group (yes | no) [yes]?
yes
Group Configuration
Group Name:
group1
Group IP address: 192.17.2.20
Do you want to use the group settings shown above (yes | no) [yes]: yes
Password for managing group membership:
Retype password for verification:
Password for the default group administration account:
Retype password for verification:
Saving the configuration ...
Waiting for configuration to become active......Done
Group member member1 now active in the group.
Group group1 has been created with one member.
Use the Group Manager GUI or CLI to set the RAID policy for the member. You can then create a
volume that a host can connect to using an iSCSI initiator.
group1>
Setting Up a Serial Connection to the Array
This section describes how to set up a serial connection between the array and a computer. You need to have a
serial connection when you use the Setup Utility to configure the array.